Related Manuals for Apevia X-Telstar
Summary of Contents for Apevia X-Telstar
-
Page 2: Table Of Contents
1. Motherboard installation...1 2. Install 3½” and 5¼” 3. Connect fan flow controller and temperature probes...5 4. LED display features...6 5. Connect front panel leads to motherboard...7 Identify power supply connectors 7. Complete the installation...9 8. USB/1394/Audio cable pin assignments...9 (All screws and case keys are provided inside of the chassis.) CONTENTS drives...3... -
Page 3: Motherboard Installation
NOTE: Processor, memory, and expansion card installation is not covered in this manual. Please refer to each components’ documentation for instructions. 1.Motherboard installation: 1.1 Remove thumbscrews from the rear of the X-Telstar. X-TELSTAR Appearance after completing installation. Push handle forward to release latch, then open and remove the... - Page 4 Remove tray from the chassis. If your motherboard included an IO shield, you must remove the X-Telstar's IO shield. Use thumbs or other object to push shield in- ward (cover area with a cloth to avoid injury from metal edges).
-
Page 5: Install 3½" And 5¼" Drives
2.Install 3½” and 5¼” drives: 2.1 To install a floppy drive, remove the 3 1/2" drive housing by placing an index finger into each inlet. Push side rails toward one another, then gently lift and slide outward. 2.3 For hard drive installation, locate and remove one of the drive cages from the bay. - Page 6 2.5 Align screw holes on the underside of the drive cage with those on the hard drive, and fasten. 2.7 Remove 5 1/4" drive bay covers by placing a finger into either inlet, firmly pressing inward, and opening. Return cage to drive bay. 2.8 Locate 5 1/4"...
-
Page 7: Connect Fan Flow Controller And Temperature Probes
2.9 Align drive rails with inlets and slide drive into place. 3. Connect fan flow controller and temperature probes: 3.1 Locate the fan flow connector coming from the front panel(black/yellow). Connect a 4-pin male fan connector to the fan flow controller. Adjust knob on front panel to control airflow. -
Page 8: Led Display Features
3.3 Place the TMPE1 probe on your CPUs heatsink. Apply a small amount of tape to hold in place. Use thermal tape for best results. Note: You may also leave a sensor loose in the chassis in order to monitor the ambient system temperature. -
Page 9: Connect Front Panel Leads To Motherboard
4.3 TMPE1 and TMPE2 display the current temperatures of components that have temp. sensors attached. The H.D.D indicator displays hard drive activity. 5. Connect front panel leads to motherboard: (Remove the right case panel to better access wiring.) 5.1 Locate the USB/Audio/1394 front panel leads. -
Page 10: Identify Power Supply Connectors
6. Identify power supply connectors (680W version): 6.1 ATX 20/24 Pin connector X 1 6.3 Peripheral connector X 8 6.5 PCI-Express connector X 2 500W version connectors: ATX 20/24 Pin X 1; ATX 12V (P4) X 1; Floppy X 2 Peripheral X 6;... -
Page 11: Complete The Installation
7. Complete the installation: 7.1 Once all components have been installed properly, gently return the side panels to their initial positions and replace the screws. Congratulations! You have completed assembly of your X-Telstar. 8. USB/1394/Audio cable pin assignments:...
Need help?
Do you have a question about the X-Telstar and is the answer not in the manual?
Questions and answers