Maintenance; Optional Accessories; Protecting The Environment - DeWalt D25711 Manual

EN GLI SH
Chipping and Chiselling (fi g. 1)
1. Insert the appropriate chisel and rotate it by
hand to lock it into one of 24 positions.
2. Set the mode selector switch (f) to the
hammering only position.
3. Set the electronic speed and impact control
dial (g).
4. Fit and adjust the side handle (c).
5. Turn the tool on and start working.
6. Always turn the tool off when work is finished
and before unplugging.

MAINTENANCE

Your D WALT power tool has been designed to
E
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
WARNING: To reduce the risk of
injury, turn unit off and disconnect
machine from power source before
installing and removing accessories,
before adjusting or changing set-
ups or when making repairs. Be sure
the trigger switch is in the OFF position.
An accidental start-up can cause injury.
This machine is not user-serviceable. Take the
tool to an authorised D WALT repair agent after
E
approximately 150 hours of use. If problems occur
before this time contact an authorised D
repair agent.
Brushes (fi g. 3)
The carbon brushes are not user-serviceable. Take
the tool to an authorized D WALT repair agent.
E
The yellow brushwear indicator LED (r) lights up
when the carbon brushes are nearly worn out. After
a further 8 hours of use or after the brushes have
completely worn out the motor will automatically be
shut offf.
Tool maintenance needs to be carried out as soon
as the service indicator (s) lights up.
Lubrication
Your power tool requires no additional lubrication.
36
Cleaning
WARNING: Blow dirt and dust out of
the main housing with dry air as often as
dirt is seen collecting in and around the
air vents. Wear approved eye protection
and approved dust mask when
performing this procedure.
WARNING: Never use solvents or
other harsh chemicals for cleaning the
non-metallic parts of the tool. These
chemicals may weaken the materials
used in these parts. Use a cloth
dampened only with water and mild
soap. Never let any liquid get inside the
tool; never immerse any part of the tool
into a liquid.

Optional Accessories

WARNING: Since accessories, other
than those offered by D
not been tested with this product, use
of such accessories with this tool could
be hazardous. To reduce the risk of
injury, only D
accessories should be used with this
product.
Various types of SDS Max
WALT
E
available as an option.
Consult your dealer for further information on the
appropriate accessories.

Protecting the Environment

Separate collection. This product must
not be disposed of with normal
household waste.
Should you find one day that your D
needs replacement, or if it is of no further use to you,
do not dispose of it with household waste. Make this
product available for separate collection.
Separate collection of used products
and packaging allows materials to be
recycled and used again. Re-use of
recycled materials helps prevent
environmental pollution and reduces
the demand for raw materials.
WALT, have
E
WALT, recommended
E
® drill bits and chisels are
WALT product
E