Using Your Oil Filled Radiator - Russell Hobbs RHOFR3001 Manual

USING YOUR OIL FILLED RADIATOR

1. Before connecting your appliance to the mains socket,
position the appliance upright on the floor, at least 90cm
away from the wall, away from curtains, furniture or wall
coverings.
2. Insert the mains plug into a suitable 13 amp mains socket.
3. Turn the Power Control to the 'I' position. The appliance
has 1 power settings.
Power Control Position
OFF Power OFF
I Power ON
4. Turn the Thermostat Control to the desired position. It is
recommended to select the highest position to pre heat
the appliance. It will take 5 -10 minutes for the appliance
to fully heat up, the time taken for the heater to heat the
room it is located in will be dependent on the size of the
room and the ambient temperature of the room. The
indicator light will illuminate when the unit is working, but
the light will cycle on and off when the thermostat control
is set on a low setting and the heater is then maintaining
the room temperature.
Note: this appliance will not operate if the thermostat has
been set too low.
Note: If the thermostat dial is set toward the highest setting
and the power control is set to off then the indicator light will
not stay illuminated. No heat will be emitted as the power to
the heating elements is off.
RHOFR3001
Off
650W
RHOFR3001 9