Programming; To Add Or Reprogram A Hand-Held Remote Control; To Erase All Codes From Motor Unit Memory; 3-Button Remotes - Chamberlain Whisper Drive Security+ HD800D Owner's Manual

PROGRAMMING

NOTICE: If this Security ✚
the receiver of the garage door opener, which provides security against code-theft devices, will be circumvented. The
owner of the copyright in the garage door opener does not authorize the purchaser or supplier of the non-rolling code
transmitter to circumvent that technical measure.
Your garage door opener has already been programmed at the factory to operate with your hand-held remote control.
The door will open and close when you press the large push button.
Below are instructions for programming your opener to operate with additional Security✚

To Add or Reprogram a Hand-held Remote Control

USING THE "LEARN" BUTTON
1. Press and release the "learn" button on
the motor unit. The learn indicator light
will glow steadily for 30 seconds.
2. Within 30 seconds, press and hold the
button on the hand-held remote
you wish to operate your garage door.
3. Release the button when the motor unit
lights blink. It has learned the code. If
light bulbs are not installed, two clicks
will be heard.
To Erase All Codes From Motor Unit
Memory
To deactivate any unwanted remote, first erase all codes:
Press and hold the "learn" button on motor
unit until the learn indicator light goes out
(approximately 6 seconds). All previous
codes are now erased. Reprogram each
remote or keyless entry you wish to use.
® garage door opener is operated with a non-rolling code transmitter, the technical measure in
* that
USING THE MOTION DETECTING CONTROL PANEL
1. Press and hold the button on the
hand-held remote * that you wish to
operate your garage door.
2. While holding the remote control button,
press and hold the LIGHT button on the
Motion Detecting Control Panel.
3. Continue holding the remote control and
LIGHT buttons while you press the push
bar on the Motion Detecting Control
Panel (all three buttons are held).
4. Release buttons when the motor unit
lights blink. It has learned the code. If
light bulbs are not installed, two clicks
will be heard.

*3-Button Remotes

If provided with your garage door opener, the large button
is factory programmed to operate it. Additional buttons on
any Security✚ ® 3-Button
remote or compact remote
can be programmed to
operate other Security✚
garage door openers.
37
® remote controls.
®