Atag VA2113RT Operating Instructions Manual page 68

Troubleshooting
Table continued from last page
Problem
Spots or films on the dishes.
The dishes have a sticky
white/blue film.
Spots left after washing.
Detergent residue in the
detergent compartment after
dishwashing.
Rattling sound when
dishwashing.
28
Possible causes
The water softener is leaking
salt.
Incorrect water softener setting.
Incorrect rinse aid dosage
setting.
Salt compartment empty.
3-in-1/ All-in-one detergent is
used and the setting TAB
(3-in-1/ All-in-one detergent) is
activated.
Too high temperature and/or too
much detergent can cause
etching on crystal.
Unfortunately, this cannot be
repaired, only prevented.
Rinse aid dosage setting too
high.
Lipstick and tea can be difficult
to wash off.
The detergent compartment was
damp when adding detergent.
The dishes are not correctly
placed or the spray arms are not
rotating.
Action
Check that the salt compartment
lid is properly tightened.
Otherwise call the service
department.
See the chapter Settings.
See the chapter Settings.
Top up with salt. See the
chapter Before washing for the
first time.
Inactivate the setting TAB
(3-in-1/ All-in-one detergent) and
top up salt and rinse aid.
Wash crystal at a low
temperature and with a
conservative amount of
detergent. Contact the detergent
manufacturer.
Reduce the amount. See the
sections Before washing for the
first time and Settings. If you
have very soft water, you may
want to dilute the rinse aid 50:50
with water.
Use a detergent with a
bleaching agent.
The detergent compartment
must be dry when adding
detergent.
Check that the dishes are
placed securely. Spin the spray
arms to make sure they can
rotate.