Troubleshooting - Atag VA2113RT Operating Instructions Manual

Type of fault on the display
F10 Overfilling
F11 Water outlet fault
F12 Water inlet fault
F40 Inlet valve leakage
F52 Water level fault
F54 Overfilling
F56 Circulation fault
Press any button to clear the error message.
Problem
The buttons do not react when
pressed.
Cannot close door.
Action
Clear the drainage pump. See the chapter Care and cleaning. If
the problem persists, call the service department.
See "Water remains in the dishwasher" in the table "Problem"
below. If the problem persists, call the service department.
Check that the water tap is on. Check that the outer filter on the
inlet hose is not blocked. See Unblocking the inlet hose filter in
the chapter Care and cleaning. If the problem persists, call the
service department.
Turn off the water tap and call the service department.
Clean the coarse and fine filters. Check that the outer filter on the
inlet hose is not blocked. If the problem persists, call the service
department.
Turn off the water tap and call the service department.
Call the service department.
Possible causes
You have pressed the buttons
too soon after opening the door.
The buttons are dirty.
The door is closed.
The baskets are not correctly
positioned.
The door lock does not click into
place and lock.

Troubleshooting

Action
Wait a moment then try again.
Clean with a dry or slightly damp
cloth.
Open the door. The buttons only
react to use when the door is
open.
Check that the baskets are
correctly positioned horizontally.
Check that the dishes are not
blocking the baskets from
sliding properly into place.
Check the door lock. If it does
not click into place and lock,
open the door.
Press and hold the button for the
Auto open option until the button
starts flashing. Wait until it stops
flashing (60 seconds). Close the
door. Check that the door lock
clicks into place and locks.
25