Atag VA2113RT Operating Instructions Manual page 59

Table continued from last page
Settings
2. Water hardness
3. TAB
(3-in-1/all-in-one
detergent)
4. Buzzer volume
Options
2:00 - 2:09 Adjusting the water softener. Select a setting depending
on the hardness of the water supply. It is important that
this setting is correct!
German water
hardness scale
0-5°dH
6-8°dH
9-11°dH
12-14°dH
15-19°dH
22-24°dH
25-29°dH
30-39°dH
40-49°dH
50°dH
Do not forget to put salt in the salt compartment after
you have set the water softener to 2:01 - 2:09.
For a water supply with a hardness under 6°dH (9°fH),
select 2:00. The water softener is deactivated and no
salt is needed.
Pre-selected at factory: 04
3:00 (Off) You can activate this setting when using 3-in-1/ All-in-one
3:01 (On) detergent. The dishwashing programs automatically
adapt to provide the best possible dishwashing and
drying results every time. If this setting is activated there
is no need to add rinse aid since this option disables
rinse aid dispensing. It also reduces the amount of salt
added to the water softener. Note that salt must be put
in the salt compartment.
In order to achieve good dishwashing results, it is
essential to check which type of detergent or all-in-one
product best suits your needs! Read the detergent
packaging carefully for information on proper use.
Always follow the directions for use or information on
the detergent packaging!
4:00 - 4:03 The dishwasher uses a buzzer to indicate when a
program is finished or when a fault has occurred.
French water Recommended
hardness scale setting
0-9°fH 2:00
10-14°fH 2:01
15-20°fH 2:02
21-25°fH 2:03
26-34°fH 2:04
35-43°fH 2:05
44-52°fH 2:06
53-70°fH 2:07
71-88°fH 2:08
89°fH 2:09
Settings
19