System Requirements; Power Connection; Ethernet Cable Connection; Alarm Connection - Grundig GCI-K1526T Owner's Manual

NOTE: Before installing the camera, please refer to the Desiccant User Guide in the package of the camera for
instructions how to place the Desiccant in the Camera to prevent moisture from condensing on the IP Camera's
Glass Cover.

4.2. System Requirements

To perform the IP Camera via web browser, please ensure your PC is in good network connection, and meets the
system requirements as described below.
Personal Computer :
1.) Intel Pentium M, 2.16 GHz or Intel Core 2 Duo, 2.0 GHz
2.) 2 GB RAM or more
Operating System :
Windows XP / Windows VISTA / Windows 7
Web Browser :
Microsoft Internet Explorer 6.0 or later
Firefox
Chrome
Safari
Network Card :
10Base-T (10 Mbps) or 100Base-TX (100 Mbps) operation
Viewer :
ActiveX control plug-in for Microsoft IE

4.3. Power Connection

Make sure the camera's power cable is correctly and firmly connected, please refer to the pin definition table in
section 4.1. Camera's Connectors. If using Power over Ethernet (PoE), make sure the Power Sourcing Equipment
(PSE) is in use in the network.

4.4. Ethernet Cable Connection

Use of Category 5 Ethernet cable is recommended for network connection; to have best transmission quality,
cable length shall not exceed 100 meters. Connect one end of the Ethernet cable to the RJ45 connector of the IP
Camera, and the other end of the cable to the network switch or PC. Connect the camera network cable and the
network cable from the switch to the RJ45 socket-socket adapter.
NOTE: In some cases, you may need use an Ethernet crossover cable when connecting the IP Camera directly to
the PC.

4.5. Alarm Connection

The camera is equipped with one alarm input and one relay output for alarm application.
Please refer to the label on the alarm terminal block and connect the alarm wiring accordingly.

4.6. Ceiling/Wall Mounting

The IR Bullet IP Camera can be installed directly on a wall or ceiling with the integrated 2-axis adjustable
Bracket Mount. Please note that the wall or ceiling must have enough strength to support the IP Camera.
Follow the steps below to install the IP Camera:
Step 1:
Take the IP Bullet Camera out of its package.
Step 2:
Connect the Power/Ethernet/Alarm/Audio wires from the ceiling or wall to the corresponding connectors of the
camera's All-in-one Cable.
English 5