Servicing Mode; Auto Off/On Button - Panasonic CS-RE18QKE Service Manual

14. Servicing Mode

14.1 Auto OFF/ON Button

1 AUTO OPERATION MODE
The Auto Operation will be activated immediately once the Auto OFF/ON button is pressed. This operation
can be used to operate air conditioner with limited function if remote control is misplaced or malfunction.
2 TEST RUN OPERATION (FOR PUMP DOWN/SERVICING PURPOSE)
The Test Run operation will be activated if the Auto OFF/ON button is pressed continuously for more than
5 seconds. A "beep" sound will occur at the fifth seconds, in order to identify the starting of Test Run
operation (Forced cooling operation). Within 5 minutes after Forced cooling operation start, the Auto OFF/ON
button is pressed for more than 5 seconds. A 2 "beep" sounds will occur at the fifth seconds, in order to
identify the starting of Forced heating operation.
The Auto OFF/ON button may be used together with remote control to set / change the advance setting of air
conditioner operation.
3 REMOTE CONTROL NUMBER SWITCH MODE
The Remote Control Number Switch Mode will be activated if the Auto OFF/ON button is pressed
continuously for more than 11 seconds (3 "beep" sounds will occur at 11th seconds to identify the Remote
Control Number Switch Mode is in standby condition) and press "AC RESET" button and then press any
button at remote control to transmit and store the desired transmission code to the EEPROM.
There are 4 types of remote control transmission code could be selected and stored in EEPROM of indoor
unit. The indoor unit will only operate when received signal with same transmission code from remote control.
This could prevent signal interference when there are 2 or more indoor units installed nearby together.
To change remote control transmission code, short or open jumpers at the remote control printed circuit
board.
* Diode is field supplied. Part number: SOD-323 IN4148WS / LMDL914T1G
 During Remote Control Number Switch Mode, press any button at remote control to transmit and store
the transmission code to the EEPROM.
Jumper A (D1)
Short with diode
D2
Short with diode
D1
45
Remote Control Printed Circuit Board
Jumper B (D2)
Open
Open Open
Short with diode
Open Short with diode
Remote Control No.
A (Default)
B
C
D