Electrolux ESF8735RKX User Manual page 19

Problem and alarm code
The appliance stops and
starts more times during
operation.
The program lasts too
long.
The remaining time in the
display increases and
skips nearly to the end of
program time.
The options of the program
have to be set again every
time.
Small leak from the appli‐
ance door.
The appliance door is diffi‐
cult to close.
Rattling/knocking sounds
from inside the appliance.
The appliance trips the cir‐
cuit-beaker.
Refer to "Before first use",
"Daily use", or "Hints and
tips" for other possible
causes.
Once you have checked the appliance,
deactivate and activate the appliance. If
Possible solution
• It is normal. It provides optimal cleaning results and
energy savings.
• Select the TimeSaver option to shorten the program
time (if applicable).
• If the delayed start option is set, cancel the delay set‐
ting or wait for the end of the countdown.
• This is not a defect. The appliance is working cor‐
rectly.
• To save your favourite configuration use option My‐
Favourite.
• The appliance is not levelled. Loosen or tighten the
adjustable feet (if applicable).
• The appliance door is not centred on the tub. Adjust
the rear foot (if applicable).
• The appliance is not levelled. Loosen or tighten the
adjustable feet (if applicable).
• Parts of the tableware are protruding from the bas‐
kets.
• The tableware is not properly arranged in the bas‐
kets. Refer to basket loading leaflet.
• Make sure that the spray arms can rotate freely.
• The amperage is insufficient to supply simultaneous‐
ly all the appliances in use. Check the socket amper‐
age and the capacity of the meter or turn off one of
the appliances in use.
• Internal electrical fault of the appliance. Contact an
Authorised Service Centre.
the problem occurs again, contact an
Authorised Service Centre.
For alarm codes not described in the
table, contact an Authorised Service
Centre.
ENGLISH 19