Kenmore PG-40405S0L Use & Care Manual page 23

Burner Electrode
□ Place the 5 burner electrode wires (thin black & thin orange), the ground wire (red capped)
and the igniter wire (large
wires are difficult to install, loosen the clamp screw, put the wires through the clamp and
retighten the screw.
□ Place the 4 thin black wires and 1 thin orange wire into the 5 narrow slots in the electronic
ignition module. Place the red capped ground wire into the slot outlined in orange. Place the
large black wire into the wide slot. See B
□ Attach the igniter cover with (2) M4x10 screws. See C (Note: If cover is hard to install, use a
screwdriver to press down on the right door heel hook to remove the door. Install the cover,
and reattach door.) See D
M4X10 screw Qty: 2 pcs
A
C
and Igniter Cover
black) through the pre-installed side panel clamp. See A. Note: If
B
D
23