Intended Use Statement The 3M Pocket Projector MP160 is designed to operate with the 3M specified battery and 3M power adapter in normal office or home environments. • 0˚–35˚C (32˚–95˚F) • 10–80% RH (without condensation) • 0–1829 m (0–6000 feet) above sea level...
Page 5
™ m Warning To reduce the risk associated with hazardous voltage: • Do not modify this product in any way. Use only 3M approved replacement components. • Do not attempt to service this projector other than battery replacement. There are no user-serviceable parts other than the battery. Service to be performed only by a 3M authorized service provider using 3M approved system components.
Page 6
• Do not immerse the battery in water or allow it to get wet. • Do not reverse the positive(+) and negative(-) terminals. • Do not connect the battery directly to a wall outlet. Use only the 3M specified wall charger or automobile charger.
Getting Started Install Battery The 3M Pocket Projector MP160 comes with a rechargeable battery. The battery should be fully charged before using the projector with the battery. To install the battery: point the contacts on the battery toward the contacts on the projector, insert the end farthest from the battery latch first, then push down until the battery clicks into place.
Page 11
Power Adapter The power adapter is used to charge the battery or power the projector. There are four outlet adapters to give you the flexibility to power the 3M MP160 projector in most countries. Installing an Outlet Adapter onto the Power Adapter Select the outlet adapter that will plug into your wall outlet.
Making Connections The 3M Pocket Projector MP160 will display informational icons depending on the input device and signal being detected. The 3M MP160 was designed to operate with the 3M VGA and AV cables only. Connecting to a Composite Video Device Use the AV cable to input video from camcorders, digital cameras, DVD players and digital media players into the VGA-AV input on the projector.
Pocket Projector MP160 ™ Connecting to a Component Video Device For component video input, you must purchase the optional 3M MP160 Component AV Cable [3M part number 78-6972-0032-3]. This cable sends a higher quality video signal for the best possible image.
The projector supports VGA, SVGA, XGA, and WXGA resolutions. For best results, set the computer’s resolution to SVGA (800x600). Connect the VGA cable to the 3M Pocket Projector MP160. Connect the VGA cable to the computer’s video and audio outputs.
Pocket Projector MP160 ™ Adjusting Image Size The 3M MP160 Projector can project a diagonal image of 10 to 80 inches (254– 2032 mm). Refer to the chart for associated dimensions. Image Size Diagonal Width 8 in (20.32 cm) 6 3/8 in (16.3 cm) 14 in (35.56 cm)
Attaching the Tripod The projector includes a table-top tripod that mounts to the bottom of the projector. Tip: The 3M MP160 Projector will attach to most camera tripods. Cleaning the Projector Turn off the projector and disconnect power and other cables.
12. The image is not visible or is very dim. • The 3M MP160 Projector is a battery-operated device and requires controlled lighting conditions. The image may appear very dim in brightly lit rooms. • Make sure the status indicator is green. This indicates that the projector is powered on and projecting an image.
All replaced parts or products become property of 3M. If the product is repaired, 3M will repair the defective part(s) with a new or used part(s). If the 3M product is replaced, 3M will replace the 3M product with the same or equivalent model and with a new or refurbished 3M product.
Page 27
This warranty does not cover consumables (e.g., batteries). This warranty is not transferable. 3M is not responsible for warranty service should the 3M label or logo or the rating label or serial number be removed unless otherwise stated in writing for the purposes of private labeling for partnership requirements.
Page 28
• The exchanged 3M product or part may be new or previously refurbished to the 3M standard of quality, and at 3M’s option, the replacement may be another model of like kind and quality. • 3M’s liability for replacement of the warranted 3M product or part will not exceed the original retail selling price of the 3M product.
RoHS, as amended:(a) 0.1% (by weight) for lead, mercury, hexavalent chromium, polybrominated biphenyls or polybrominated diphenyl ethers; or (b) 0.01% (by weight) for cadmium. This information represents 3M’s knowledge and belief, which may be based on information provided by third party suppliers to 3M.