Remote Start Troubleshooting - ADS TR2310AC Owner's Manual

1. Unlock and enter vehicle
2. Close doors
3. Insert key into ignition and turn ignition to ON position
4. Press foot brake
For Push-To-Start Vehicles
1. Unlock and enter vehicle with valid smartkey
2. Close doors
3. Press foot brake
NOTE: This feature may not be supported on some vehicles. If available, the programmed 'key takeover' delay
time will be communicated to you by your iDatastart Authorized Dealer at the time of installation.
WHEN SERVICING YOUR VEHICLE
To ensure safety during vehicle servicing, the remote starter must be placed in 'Valet Mode'. The 'Valet Mode'
will disable remote start functionality. To activate or deactivate the 'Valet Mode', follow the instructions below:
With Vehicle Key:
Cycle ignition OFF/ON 2x rapidly, then press brake 3x.
FUNCTION
Valet Mode ON
Valet Mode OFF
With iDatastart Antenna:
Turn ignition ON, then press & hold button for 5 seconds
FUNCTION
Valet Mode ON
Valet Mode OFF

REMOTE START TROUBLESHOOTING

If your iDatastart remote fails to start the vehicle, the parking lights will flash three times immediately, then
# OF PARKING LIGHT FLASHES
1
2
# OF PARKING LIGHT FLASHES
1
2
2022-03-4 © Automotive Data Solutions Inc. 6/11
TR2310AC