Operational Control - Denver SEL-65230 Translation Of The Original Manual

8. Operational control

For better operation, please read the instructions carefully.
8.1 Button
There are three buttons in the display,
8.2 Control and display
Battery
Gear
Power On: Long press the power button until the display lights up.
Power Off: Long press the power button until the display goes out and the system is off.
1. Battery power display: it shows the current remaining battery capacity.
2. Power off automatically: After the display is idle for more than 5 minutes, the Electric scooter automatically turns off.
 Change display information: When the Electric scooter is on, short press the power button
showing data on the display, TIME, ODO, DIS and other characters respectively. When it is showing time, it
indicates the running time after switching on. The time will be cleared after switching off. When it is showing DIS, it
indicates the driving distance after switching on, and it will be cleared after power off. When it is showing ODO, it
indicates the total mileage, which will be retained unless it is manually cleared.
 Change the gear: Short press ▲ or ▼ button to change the gear level (Gear 3 is fast speed, Gear 2 is medium
speed, and Gear 1 is slow speed).
 Deceleration: Gently press the deceleration dial to slow down. The deeper the press, the greater the deceleration
(the deceleration is relevant to the formation of the press, and pushing too hard cannot increase the braking force
and may cause damage to the brake dial).
 Clear total mileage: Press ▲ and ▼ buttons at the same time, then press the power button
Electric scooter, and the total mileage will be cleared.
Electric brake button
Power button, ▲ Speed up button and ▼ speed down button.
Single Mileage
Speed down button
Accelerator button
11
Speed up button
Power button
Speed
KM
Time
, change the
to switch on the