Table of Contents
Advertisement
TrackDrive (TD) Series
Operating & Safety Instructions
3)
Hi/Low Drive
4)
Power Control Button – Press and hold Green button to enable machine.
5)
Duty Selector – Three position control allows operator to select between:-
6)
Selector switch – Turn to 'On' position to enable machine controls.
7)
Glow/Start Selector – Turn to the left and hold for 3 – 4 seconds to energise the glow function
before starting. Turn to the right to fire the engine, release when engine fires.
8)
Cage Weigh – Illuminates if Safe Working Load (SWL) has been exceeded in Cage.
9)
Tilt Alert – Illuminates when excess drive angle is detected. High speed drive is lost until
machine returns to level.
10)
Water Temperature – Illuminates if coolant temperature is too high.
11)
Engine Oil Pressure – Illuminates and buzzer sounds if pressure drops. Check oil level. Note;
Will also activate when Selector (6) is turned 'ON', until engine has been started and run to
achieve correct pressure.
12)
Track Width – Increases or decreases width of tracks when used with Power Control Button.
13)
Horn – Operates audible alarm.
14)
LH Track Direction – Switches between Forward and Reverse.
15)
RH Track Direction – Switches between Forward and Reverse.
4.4.2
BOOM FUNCTIONS
1)
Push and hold green "Power Control" button
1
2)
Select lever 1, 2, 3, 4 or 5 for desired function
30
Left: Jacks/ Outrigger operation
Centre: Booms only
Right: Track Drive and variable width control.
2
3
P14927/001
4
5
English/USA 12/09
Courtesy of Crane.Market
Advertisement
Table of Contents
