Table of Contents
Advertisement
TrackDrive (TD) Series
Operating & Safety Instructions
3.3.3
MONTHLY SAFETY CHECKS
1)
Check the engine oil level (if applicable).
2)
Check outriggers for condition, security and operation.
3)
Check that the slew gearbox is secured and correctly in mesh. Clean and re-grease.
4)
Grease the slew ring.
5)
Inspect the engine fuel tank for damage or leaks.
6)
Check telescopic boom wear pads and nylon studs (if applicable).
7)
Check that the end cap on the main knuckle pin is secure and the roll pin is in place.
8)
Lightly oil the jack pad ball joints and outrigger housings.
9)
Check and adjust if necessary the Nylatron studs around the telescope boom.
10)
Every three months check and verify the calibration of the cage weigh system (If fitted).
See section 4.5.4 for the calibration procedure.
11
Every Six months perform a thorough examination in accordance with the 'Lifting Operation
and Lifting Equipment Regulations' (LOLER) 1998, Regulation (9)(3)(a).
3.3.4
ANNUAL SAFETY CHECKS
1)
Check that all pivot pins and their tag bolts are secure.
2)
Inspect for any cracks or badly rusted areas on booms and chassis.
3)
Change the hydraulic oil and the oil filters.
4)
Check that slew ringbolts are secure (torque 155ft lbs. 210Nm).
5)
Inspect hose track for damage or missing parts.
14
English/USA 12/09
Courtesy of Crane.Market
Advertisement
Table of Contents
