Table Of Contents; Important Safety Instructions - AGA marvel 3OiMT Installation, Operation And Maintenance Instructions

Materials supplied .............................................................. 2
Tools Required ...................................................................3
Drain pump installation ..................................................... 3
Converting a gravity drain model ................................ 3
Replacing an existing drain pump ..................................8
Drain pump maintenance ..................................................10
Troubleshooting ................................................................11

Important Safety Instructions

Warnings and safety instructions appearing in this guide
are not meant to cover all possible conditions and situa-
tions that may occur. Common sense, caution, and care
must be exercised when installing, maintaining, or operat-
ing this appliance.
Recognize Safety Symbols,
Words, and Labels.
WARNING
!
WARNING-
Hazards or unsafe practices with
high probability of personal injury or property / prod-
uct damage.
CAUTION
!
CAUTION-
Hazards or unsafe practices which could
result in personal injury or property or product damage.
NOTE
NOTE-
Important information to help assure a problem
free installation and operation.
"P" clamps
and screws
(for 18"
vent tube)
18" wire
harness
Shipping
block
CONTENTS
18" vent
tube
Drain pump
Figure 1
The Marvel drain pump is designed to remove drain water
from ice machines installed in areas without direct drain-
age access. The sealed reservoir pump collects the melted
ice water and pumps it to a maximum lift of eight (8) feet
through ⁄ " I.D. vinyl tubing to a drain.
3
8
CAUTION
!
This pump has been evaluated for use with water only.
This drain pump is designed to be installed in Marvel ice
machines only.
!
Risk of electrical shock: Unplug product from
electrical outlet before installing drain pump or
whenever inspecting or servicing product. This
pump is supplied with a grounding conductor and
a grounding-type attachment plug. To reduce the
risk of electric shock be certain it is connected to a
properly grounded receptacle.
Despite the ease of installation reasonable care and safe
methods should be practiced. Do NOT work with energized
electrical equipment in a wet area. Read and follow the
installation instructions listed in this manual.
Materials supplied: (See Figure 1).
(1) Marvel drain pump, 115VAC/60Hz
(1) 20 foot x ⁄ I.D. discharge tubing
3
8
(1) 18 inch x ⁄ I.D. vent tube
3
8
(2) "P" clamps
(2) #10 x ⁄ Screw
1
2
(3) hose clamps
(1) 18" wire harness
(1) shipping block
Hose
clamps
20' discharge
tubing
2
WARNING
NOTE
For future reference record
the drain pump serial number
(from the label on the end of the
drain pump) and also the model
number and serial number of the
ice machine on page 11 of these
instructions. The ice machine
model and serial numbers are
on the serial plate inside the ice
machine on the left wall.