Daikin FTX20J3V1B Operation Manual page 14

 To start COMFORT AIRFLOW operation
3. Press "COMFORT AIRFLOW button".
• The position of the flap will change, preventing air from blowing directly on the occupants of
the room.
• " " is displayed on the LCD.
• Airflow rate is set to "AUTO".
COOL/DRY The flap will go up.
HEAT The flap will go down.
 To cancel COMFORT AIRFLOW operation
4. Press "COMFORT AIRFLOW button" again.
• The flap will return to the memory position from before COMFORT AIRFLOW mode.
• " " disappears from the LCD.
Notes on COMFORT AIRFLOW operation
• POWERFUL operation and COMFORT AIRFLOW operation cannot be used at the same
time. Priority is given to POWERFUL operation.
Notes on flaps and louvers angles
• When "SWING button" is selected, the
swinging range of the flap depends on the
operation mode. (See the figure.)
 ATTENTION
• Always use a remote controller to adjust the
angle of the flap. If you attempt to move it
forcibly with hand when it is swinging, the
mechanism may be broken.
• Be careful when adjusting the louvers. Inside the
air outlet, a fan is rotating at a high speed.
• If the air conditioner is operated in cooling or dry
mode with the flap kept stopped in the downward
direction, the flap will automatically start operating
in approximately an hour in order to prevent dew
condensation.
13
In DRY mode or COOL mode
Stop operation
COMFORT AIRFLOW
Upper limit (SWING)
Lower limit (SWING)
In HEAT mode
Stop operation
Upper limit (SWING)
Lower limit (SWING)
COMFORT AIRFLOW
In FAN mode
Stop operation
Upper limit (SWING)
Lower limit (SWING)