Switching On The Appliance; Timer Programming; End Of Programme; Interrupting The Programme - Bosch SPI50E65EU Instruction Manual

Switching on the appliance

1. Turn on the tap fully.
2. Close the door.
3. Switch on ON/OFF switch (.
The Cleaning display )* flashes.
4. Rotate programme selector 8
to the required programme.
5. Press START button @.
The Cleaning display )* is lit. The
programme starts running.
Note
- for environmentally friendly operation
of the dishwasher:
The Eco 50° programme is a
particularly environmentally friendly
programme. According to EU
regulation 1016/2010 it is the
"Standard programme" which is the
most efficient standard cleaning cycle
for cleaning normally soiled utensils in
terms of the combined energy and
water consumption for cleaning these
types of utensils.
T imer programming *
T i m e r p r o g r a m m i n g
* depending on model
You can delay the start of the
programme by 3, 6 or 9 hours.
1. Switch on ON/OFF switch (.
2. Keep pressing the Preselected
starting time button H until the
appropriate display 3h, 6h or 9h is lit.
3. Press START button @, timer
programming is activated.
4. To delete the preselected starting
time, keep pressing the Preselected
starting time button H until none of
the displays 3h, 6h or 9h is lit.
You can change your programme
selection at any time until the
programme starts.
Operating the appliance

End of programme

The programme has ended when
neither of the two displays )" or )* is
lit.
Note
To save energy, the dishwasher
automatically switches off after the end
of the programme.

Interrupting the programme

1. Switch off ON/OFF switch (.
The LEDs go out. The programme is
saved.
If the door was opened on an
appliance which has a warm water
connection or is heated, first leave
the door ajar for several minutes and
then close. Otherwise, expansion
(pressure) may cause the appliance
door to spring open or water to run
out of the appliance.
2. To continue the programme, switch
on the ON/OFF switch ( again.
T erminating the programme
T e r m i n a t i n g t h e p r o g r a m m e
(Reset)
1. Press START button @ for
approx. 3 sec. until all displays go
out.
2. The remaining programme sequence
for draining the residual water takes
approx. 1 minute.

Changing the programme

When the START button @ has been
pressed, the programme cannot be
changed.
The only way a programme can be
changed is by Cancel programme
(Reset).
en
23