Advertisement
The control panel must be armed prior to
vacating the premises in ord e r to detect
intruders. Ensure that the panel is not in
Program, Memory or Exclude modes.
N O T E : If the panel is already in alarm,
you must first silence the alarm before you
can arm.
These are three methods of arming the panel:
1.
C H E C K that the ready light is on by closing all windows and doors.
2.
P R E S S
or
3.
The arm light should be ON.
4.
L E AV E the premises within your exit delay time.
5.
At the end of the exit delay time, three beeps will sound.
To Arm your system with the optional radio keys follow the sequence below;
1. Check that the ready light is on by closing all doors and windows.
2. Press the 'ON' button on your radio key. The keypad will beep three times and the
armed light will come on.
3. Leave the premises within the exit delay time.
4. The keypad will beep three times at the end of exit time.
Note: If Arming from outside it is possible to have the outside siren pop and the strobe
to flash for two seconds to indicate that the system has been armed.
If something is wrong when Arming the
control panel, the normal 3 beeps will be
eplaced by other warnings.
• Mains power is turned off
• Control Panel battery is low
• A long beep indicates an invalid entry
or an alarm is outstanding and needs
to be reset by entering your access
code first.
A R MI N G Y O U R A L A R M S Y S T E M
..Enter..
Arm
Arm
code
1.
Normally the panel is armed by pressing
Arm then Enter.
2.
Your installer may have programmed the
panel to require the entry of a code to arm
the panel.
3.
Using an optional radio key to arm the
panel by pressing the 'on' button.
..Enter..
SIREN WARNING:At the end of the exit time,
all zones should be secured. If any are unse-
cured, the siren will sound for 2 seconds as a
warning to indicate that those zones h a v e
been automatically excluded. For m a x i m u m
s e c u r i t y, you should re t u rn , DISARM, check the
premises and then ARM again. Continual
warnings could mean that a detector is faulty
and may have to be manually excluded.
If the auto-exclude option is disabled, the siren
will sound for the duration of reset time if a
zone is unsecured at the end of exit time.
9
Ready
Advertisement
