Ness Security Products D-8 Owner's Manual page 16

The D-8 Control Panel contains an compre-
hensive Alarm Memory. The D-8 will remem-
ber Arms, low battery, mains fail and alarms.
The memory is constantly upgraded and the
ast 20 events are always available for viewing.
To view the memory display, enter...
<Memory> <Enter> will show the last event,
pressing <Memory> again will show the
previous event etc
1.
To view memory , press...
2.
OBSERVE lights .
The last event will be displayed. Press the Memory button to view the previous
event, Press the Memory button again to view the previous event etc until all
events have been displayed.
The lights are used as follows:
Light
Zone light
Arm light
Tamper light
Exclude
Battery light
Mains light
Radio, Battery, Zone
Radio, Battery, Arm
You can access the Alarm Memory as often as required
while the Panel remains Disarmed.
You can exit Memory Mode at any time by pressing the Enter Key.
A L A R M M E M O R Y
or
<Memory> <code> <Enter> will show the
last event, pressing <Memory> again will
show the previous event etc
This Memory display can only be selected
while the panel is in the Disarmed state.
N O T E : Entry to Program Mode will clear
the events from Alarm Memory.
Memory
Alarm
Zone alarm
Panel armed
Tamper alarm (siren cover, panel etc.)
Panic alarm
Low battery
Mains failure
Radio Device Low Battery
Radio Key Low Battery
16
..Enter..