Advertisement
If a detector becomes faulty and cannot be
secured when arming the panel, then its
zone may be excluded so that it does not
generate alarms.
To enter Exclude mode press,
<Exclude> <Enter>
or
<Exclude> <code> <Enter>
All the lights will be turned off and then the
1.
To exclude zones...
2.
Press...
or
the Exclude light should be On
3.
ENTER the zone/s to be EXCLUDED
4.
To EXIT press ENTER
If you make a mistake, enter the zone number again to remove it from your selection.
Zones which you exclude will be identified by the relevant zone indicator showing a steady
light in the exclude mode.
N O T E : Your Control Panel may be programmed to automatically exclude faulty zones
whenever you Arm. The Exclude light will flash as a warning or memory of the auto-exclusion.
If Auto - Exclude is selected the outside Siren will sound for 2 seconds indicating a zone has
Auto Excluded.
E X C L U D I N G Z O N E S
Zone Excluded indicator will show a steady
light. You may now exclude zones.
To exclude, say, zones 4 and 8, press the
buttons...
<Exclude> <Enter>
4 <Enter> 8 <Enter>
Zone lights 4 and 8 will turn on.
<Enter> to Exit Exclude Mode
N O T E : Excluding zones can only be done
when the panel is disarmed.
Exclude
code
Exclude
..Enter..
14
..Enter..
..Enter..
Zone No.
..Enter..
Advertisement
