Advertisement
Monitor mode allows you to arm selected
zones while others are ignored. Typically,
perimeter zones (doors and windows) can be
m o n i t o re d while you are at home.
To select Monitor mode,
A) press <Monitor> <Enter>
or
<Monitor> <code> <Enter>
The control panel will respond with 3 beeps
and the armed indicator will f l a s h to indicate
that you are in M o n i t o r mode.
1.
To E N T E R monitor mode, press...
2.
If an A L A R M occurs, the respective zone light will flash.
3.
To S I L E N C E the alarm
and to exit monitor, press...
Entering Monitor Mode with Radio Keys
1. Press the 'OFF' button twice within five seconds on any programmed Radio Key. The
Armed light will flash and the key pad will beep three times to indicate monitor mode.
2. If an alarm occurs the respective zone light will flash.
3. To silence the alarm and exit monitor mode press the 'OFF' button once. The armed
light will go out and the keypad will beep three times.
MO N I T O R M O D E
Monitor mode cannot be selected while in
Program, Memory or Exclude modes.
To exit from Monitor mode: press,
<code> < Enter> to disarm.
N o t e :
If an alarm occurs while in Monitor mode,
entering <code> <Enter> will silence the
alarm. This will also change the mode of
operation of your panel, so remember to
enter monitor mode again if necessary.
Monitor
code
11
..Enter..
..Enter..
Advertisement
