Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for SNOWJOE Sunjoe 24V-X2-CS16-RM
Summary of Contents for SNOWJOE Sunjoe 24V-X2-CS16-RM
- Page 1 CORDLESS CHAIN SAW 48-VOLT MAX* | 2.0 Ah | 16-INCH OPERATOR’S MANUAL Model 24V-X2-CS16-RM A Division of Snow Joe , LLC Form No. SJ-24V-X2-CS16-RM-880E-MR3-V2 ® © 2021 by Snow Joe , LLC SAVE THESE INSTRUCTIONS ® All rights reserved. Original instructions.
-
Page 2: General Safety
CORDLESS CHAIN SAW 48-VOLT MAX* | 2.0 Ah | 16-INCH OPERATOR’S MANUAL Model 24V-X2-CS16-RM A Division of Snow Joe , LLC ® Form No. SJ-24V-X2-CS16-RM-880E-MR3-V2 IMPORTANT! Improper use of the machine will invalidate the warranty, relieve the manufacturer from all liabilities. The user will Safety Instructions consequently be liable for all and any damage or injury to himself/herself or others. -
Page 3: Personal Safety
Personal Safety before use – Many accidents are caused by poorly maintained power tools. 1. Stay alert, watch what you are doing and use common 6. Keep cutting tools sharp and clean – Properly sense when operating a power tool. Do not use a maintained cutting tools with sharp cutting edges are less power tool while you are tired or under the influence likely to bind and are easier to control. -
Page 4: Causes And Operator Prevention Of Kickback
• Hold the power tool by insulated gripping surfaces exclusively upon the safety devices built into your saw. As a only, because the saw chain may contact hidden chain saw user, you should take several steps to keep your wiring. Saw chains contacting a "live" wire may make cutting jobs free from accident or injury. -
Page 5: Information About The Battery
® ® misuse will permanently disable or damage the battery pack. 1-866-SNOWJOE (1-866-766-9563) for assistance. • Avoid dangerous environments – Do not charge the • Battery chemicals cause serious burns – Never let a battery packs in rain, snow or in damp or wet locations. -
Page 6: Protection From Environmental Influences
+ Sun Joe ® ® ® in overheating and cell damage. Never charge or work customer service center at 1-866-SNOWJOE with batteries that have been overheated – replace them (1-866-766-9563). immediately, if possible. 3. Electrical plugs must match the outlet. Never modify 7. -
Page 7: Safety Symbols
Safety Symbols The following table depicts and describes safety symbols that may appear on this product. Read, understand, and follow all instructions on the machine before attempting to assemble and operate. Descriptions Symbols Symbols Descriptions READ THE OPERATOR'S DANGER! ROTATING MANUAL(S) –... -
Page 8: Technical Data
Know Your Cordless Chain Saw Read the owner’s manual and safety instructions carefully before operating cordless chain saw. Compare the illustration below to the cordless chain saw in order to familiarize yourself with the location of the various controls and adjustments. Save this manual for future reference. -
Page 9: Carton Contents
+ Sun Joe customer service center at ® ® 1-866-SNOWJOE (1-866-766-9563). NOTE: If the charge level button does not appear to be working, NOTE: Do not discard the shipping carton and packaging connect the battery to the charger and charge as needed. -
Page 10: Charging The Batteries
+ Sun Joe customer service center at ® ® 1-866-SNOWJOE (1-866-766-9563) for assistance. 6. When charging is complete, remove the batteries from the charger by pressing the push lock buttons and sliding the batteries backward to unlock them from the charger Push lock button (Fig. -
Page 11: Preparing To Work
Preparing To Work NOTE: Pay attention when loosening the chain by turning the end cover + chain tensioning knob counterclockwise. If loosened excessively, the knob and end cover may come off. Checking the Machine 2. The tension is correct when the drive links on the chain do not slip out of the chain guide on the bar when the chain WARNING! Before performing any checks,... -
Page 12: Operation
IMPORTANT! Before each use, the oil level should be checked WARNING! Do not let familiarity with this type of tool and topped up to 1 cm from the rim of the filler. To fill the oil prevent you from taking all necessary precautions. Remember tank, remove the oil tank cap and add the recommended bar that a careless fraction of a second is sufficient to inflict and chain oil. -
Page 13: Operating Tips
+ Sun Joe customer service center at ® Lights Light Indicators 1-866-SNOWJOE (1-866-766-9563) for assistance; – When the machine is not in use. Yellow The saw is ready to make a cut IMPORTANT! Always remember that an incorrectly used Green... -
Page 14: Cutting Techniques
• To avoid the risk of fire, do not leave the machine with the motor hot on leaves or dry grass. Fig. 14 Straight arm Chain line WARNING! It takes specific training to use the machine for felling and delimbing. Checks During Work •... - Page 15 Make the lower horizontal notching cut first. This will help to WARNING! Stop the motor immediately if the chain avoid pinching either the saw chain or the guide bar when the stops during sawing. Beware of kickback, which can occur if second notch is made.
-
Page 16: Maintenance
+ Sun Joe customer service center ® ® at 1-866-SNOWJOE (1-866-766-9563) for all maintenance operations not foreseen in this manual. Any operation performed in an unauthorized service center or by unqualified personnel will completely invalidate the warranty. • When the log is supported on both ends (Fig. 18C), cut... -
Page 17: Motor Cooling
+ Sun Joe customer ® ® ® service center at 1-866-SNOWJOE (1-866-766-9563). 3. Remove the old chain from the bar. WARNING! 4. Lay out the new saw chain in a loop and straighten The operation should be completed on a any kinks. -
Page 18: Chain Tension
Fig. 26 Fig. 23 End cover + chain tensioning knob Pull to stretch Loop NOTE: The chain is correctly tensioned when there is no sag on the underside of the guide bar; the chain is snug, 6. Mount the guide bar by inserting the stud bolt into the but can be rotated by hand without binding. -
Page 19: Chain Sharpening
Visit sunjoe.com or call the Snow Joe ® they occur. Sun Joe customer service center at 1-866-SNOWJOE ® (1-866-766-9563) to order. Replace a bar with any of the following faults: Otherwise, use special round-section files with the right diameter •... -
Page 20: Troubleshooting Tips
• Check the chain tension. adjustments, please call 1-866-SNOWJOE (1-866-766-9563) • Check the chain teeth for sharpness. for assistance. • Check the bar and chain oil level; fill with only new chain... -
Page 21: Service And Support
If your Sun Joe 24V-X2-CS16-RM cordless chain saw ® requires service or maintenance, please call 1-866-SNOWJOE (1-866-766-9563) for assistance. Model and Serial Numbers When contacting the company, reordering parts, or arranging service from an authorized dealer, you will need to provide the model and serial numbers, which can be found on the decal located on the housing of the unit. -
Page 22: Optional Accessories
Optional Accessories WARNING! ALWAYS use only authorized Snow Joe + Sun Joe replacement parts and accessories. NEVER use ® ® replacement parts or accessories that are not intended for use with this saw. Contact Snow Joe + Sun Joe if you are unsure ®... - Page 23 ® changes. Accessories can be ordered online at sunjoe.com or via phone by contacting the Snow Joe + Sun Joe customer ® ® service center at 1-866-SNOWJOE (1-866-766-9563). Chain Maintenance Table File Diameter Drive Links Chain Pitch Chain Gauge inches...
- Page 24 @snowjoe. • Wearing parts like belts, augers, chains and tines are not covered under this warranty. Wearing parts can be EXPORTS: purchased at snowjoe.com or by calling 1-866-SNOWJOE Customers who have purchased Snow Joe + Sun Joe ®...
Need help?
Do you have a question about the Sunjoe 24V-X2-CS16-RM and is the answer not in the manual?
Questions and answers