Table of Contents
Advertisement
Starting a program
1. Check that the water tap is open.
2. Press the START/PAUSE key.
The program is started or it starts after the time delay set has elapsed.
If after pressing the START/PAUSE key the display shows "Door not
Closed", the door has not been shut properly. Push the door firmly
closed and press the START/PAUSE key again.
Program progress
The display indicates the
stage of the program that is
currently being performed as
well as the time of the end
of the program.
During the washing cycle the
time of the end of the pro-
gram may change as the
program adjusts itself to different conditions (e. g., type and quantity
of laundry, out of balance spin detection, special rinses, etc.).
Interrupting a program/adding washing
Interrupting a program
• The wash program can be interrupted at any time by pressing
the START/PAUSE key. It is then re-started by pressing the key again.
• To stop the washing machine before the program has ended, turn the
program knob to OFF.
Important: Be careful if there is water in the appliance!
Adding washing
1. Press the START/PAUSE key.
• If "Door locked" and "Pause" are alternately shown in the display, it is
no longer possible to add washing, e. g. when the water level is too
high.
• If "Door openable" and "Pause" are alternately shown in the display, it
is still possible to add washing:
2. Open the door.
3. Add washing and close the door again.
4. Press the START/PAUSE key again. The program continues.
LINEN/EASY CARE
Washing
50C 800 aýýýýýaýaýaýaýaýaýaýaýa
TEMP.
RPM
OPTIONS
12.45
14.37
OK
TIME
19
Advertisement
Table of Contents
