Installing Trueflex Bottle Organizers - True GDM-06-LD Installation Manual

INSTALLING
NOTE
When installing shelves, be sure to plan
adequate space between shelves for
product to be stocked and removed.
Step 1
Install wire shelves so rear shelf clips are four slots higher than
front shelf clips (for gravity feed). To prevent shelves from
sliding forward be sure to install shelf retainer clips (image 1).
Step 2
Place TrueFlex organizer along tank side. Guide
bottom tabs between the first and third wire
supports as shown (image 2).
Step 3
Firmly press and slide hand along inside of
TrueFlex organizer until it snaps in place on top of
shelf (image 3). Tabs grip between shelf wire
supports (image 3a).
Step 4
Line up second TrueFlex organizer against the side
of the first one and press into place as before.
Continue the process until shelf is filled out
(image 4).
NOTE
Organizers may not fill entire width of shelf.
24
INSTALLATION / OPERATION INSTRUCTIONS
5
............ www.truemfg.com ............
BOTTLE ORGANIZERS (20 OZ.)
Shelf retainer clip installation,
both sides. (retainer clip
position varies depending on
model, GDM-12 shown)
2
Press organizer down until
bottom tabs snap into
place between shelf wire
supports.
3a
Organizers in place.
True Food Service Equipment, Inc.
1
3
4
Organizers merchandised
with 20 oz. bottles.
Guide bottom tabs
between first and third
wire supports.
Tabs snap in place under
wire shelf supports.
24