Table of Contents
Advertisement
4. Operation
Wear protective gear at all times when operating auger, such as hard
hats, protective shoes, eye protection, and gloves. Do not wear loose
clothing, and be sure that hair is tied back.
4.1 Pre-Operation Checklist
Before operating the auger, the operator must follow this checklist:
All safety shields are in place, secure, and in good working order.
Lift cable is properly aligned in pulley. Clamps are secure.
Fasteners are secure.
PTO driveline is securely attached to driveshaft and tractor.
PTO driveline rotates freely.
PTO driveline telescopes easily.
Tube alignment is reasonably straight.
Auger wheels and tractor wheels are chocked.
Intake hopper and discharge spout are free of any obstructions.
A second qualified person is present during operation.
All operators have read manual and are aware of safety
precautions.
Maintenance has been performed properly.
Power to PTO and hydraulic system is in off position before
starting tractor.
Hydraulic system has been thoroughly checked for leaks. (see
Section 5 "Hydraulics" for details).
4.2 Auger Drive & Lockout
The proper operation of this auger requires that the operator pre-inspect
the drive system, know how to shut down the system in an emergency,
and generally monitor the system during operation.
Drive System and PTO Driveline: Ensure that the PTO drive on the tractor
is in the off position before starting the tractor. Stay clear of PTO hazard
area. Do not exceed the maximum operation length of 80 inches of PTO
driveline, or the maximum angularity of 30 degrees.
Lockout/Shutdown of PTO Driveline: Turn off engine. Remove ignition key
from tractor. If for some reason, you cannot remove the key, remove the
PTO driveline from the tractor.
11
Advertisement
Table of Contents
