Table of Contents
Advertisement
Interface Connectors
2 3 4 5
1
Figure 2: Rear Connectors
# Connector
Press and hold for 15 seconds to
1
Reset
factory reset the device.
Console
RJ45 console port for connection to
Port
a management computer.
10/100/1000 Mbps Ethernet
LAN Port
LAN port (non-PoE).
LAN (PoE)
2.5 Gbps Ethernet port for data and
4
Port
Power over Ethernet (PoE) power.
Input for the power adapter;
however, the device can also be
powered over Ethernet.
Power
5
Input
Note: An 802.3at PoE injector is not
included in the package contents,
but can be purchased separately.
Table 2: Interface Description
Installation
The DAP-X2850 can be powered using one of
the following two methods:
2
Description
Using Power over Ethernet (PoE)
1.
Use a standard Ethernet cable to connect
the LAN port on the DAP-X2850 to a PoE
power source device such as an 802.3at
PoE switch or 802.3at PoE injector.
Using a Power Adapter (Optional)
1.
Connect the power connector of the
adapter to the power input on the
DAP-X2850 and plug the adapter into a
nearby power outlet.
Configuration
Using Nuclias Connect
The DAP-X2850 is designed to be managed
through Nuclias Connect. Refer to the Nuclias
Connect Manual for detailed configuration
instructions.
Manual Configuration
Note: D-Link recommends manually configuring
the device before mounting it. The management
computer, DHCP server and DAP-X2850 must be
in the same subnet.
Use one of the following methods to access the
web user interface:
Connecting through Ethernet
1.
Use an Ethernet cable to connect the
DAP-X2850 to the management computer,
or to the switch or router the management
computer is connected to.
2.
Manage the access point from a computer.
Enter dapx2850.local in the address field
of your browser.
DAP-X2850 Quick Installation Guide
Advertisement
Table of Contents
