Table of Contents
Advertisement
Quick Links
EoC Transmitter & Receiver – 1 RJ45 and 1BNC Port
Introduction
The KBC EECN1-LN1-T-MX-B is a fully ruggedized Ethernet over Coax
transmitter and the EECN1-LN1-R-MX-B is a fully ruggedized Ethernet over
Coax receiver. This product provides connectivity for one 10/100Mbps IEEE
standard twisted pair copper port over a 75ohm coaxial cable. Varying data
rates are supported depending on cable distance and quality. The plug-and-
play design ensures ease of installation with no electrical adjustment needed.
LED indicators are provided to show the operational status of the unit.
The size of the transmitter is suited for fitting inside camera housings and
where space is minimal.
Features
•
1 UTP port and 1 coax port
•
12~24VDC power input
•
Coax data rate >50Mbps (700m) based on coax quality
•
Complete protection design including surge protection and lightning
protection
Downloads
Full specifications, features and additional information can be found on the
relevant product page on the KBC website as well as in the downloads section:
www.kbcnetworks.com
QSG-EECN1-LN1-X-MX-B_Series-Rev1904
Copyright © KBC Networks 2019
Quick Start Guide
EECN1-LN1-X-MX-B
eCopper™
www.kbcnetworks.com
Advertisement
Table of Contents
Related Manuals for KBC eCopper EECN1-LN1-X-MX-B
Summary of Contents for KBC eCopper EECN1-LN1-X-MX-B
- Page 1 Complete protection design including surge protection and lightning protection Downloads Full specifications, features and additional information can be found on the relevant product page on the KBC website as well as in the downloads section: www.kbcnetworks.com QSG-EECN1-LN1-X-MX-B_Series-Rev1904 www.kbcnetworks.com Copyright © KBC Networks 2019...
- Page 2 General Check the product upon receipt for any visible damage which may have been caused during shipping. Physical Deployment This equipment must be installed and operated in accordance with instructions found in this document. Failure to comply with these instructions will invalidate warranty.
-
Page 3: Panel View
Top View (Receiver) Panel View Coax panel Ethernet panel 1 - Power input; 2 - LED indicators; 3 – Coaxial cable connecter; 4 - Ethernet RJ45 port; 5 – Grounding terminal Color Status Description Green Power supply is normal. C-LINK Green EoC connection is normal. -
Page 4: Specifications
Signal Dimensions (Unit = mm) Equipment: Installation Accessories: Specifications Page 4 of 8... -
Page 5: Installation Instructions
Item Description Power Input 12/24VDC Power Consumption <2W 75-5 or above coaxial cable and Transmission Medium Cat5e/6 cable Operating Frequency 2M~28M Modulation Wavelet-OFDM Transmission Rate 210Mbps (Max.) Cable Power Negotiation Cycle Overcurrent 720mA Overcurrent Protection Time <2mS Transmission Distance 700m Transmission Medium Cat5e/6 Ethernet Port... - Page 6 Please check the following items before installation. If any missing, please contact the dealer. EoC transmitter/receiver----------- x1 ⚫ Wall mounting clamp---------------- x1 ⚫ QSG/User manual-------------------- x1 ⚫ Screw---------------------------------- x2 ⚫ Please follow the installation steps below: Attach the clamp to the wall using the 3X10mm screws; Press the transmitter/receiver into the clamp;...
-
Page 7: Troubleshooting
If the problem still exists, please contact the dealer. Warranty Information KBC Networks extends the Limited Warranty to the original owner/purchaser of this product in according to the Warranty Policy posted in KBC Networks’ website at www.kbcnetworks.com. KBC Networks extends the following Limited Warranty to the original... - Page 8 The cost of the repaired or replaced parts or portions of this product; d) No other expressed or implied warranties have been made or will be made on behalf of KBC Networks with respect to the sale, repair, installation, operation, or replacement of this product. KBC Networks disclaims any implied warranty of merchantability of this product or its fitness for any purpose, and the buyer agrees that this product is sold “as is”...