Summary of Contents for KBC eCopper EERN1-LN1-X-MX-B
Page 1
EoU Transmitter & Receiver - 1 UTP Connecter and 1 RJ45 Introduction The KBC EERN1-LN1-X-MX-B is a fully ruggedized Ethernet over UTP transmitter and receiver set. This product provides connectivity for one 10/100Mbps IEEE standard electrical copper port over UTP cable. Varying data rates are supported depending on cable distance and quality.
Page 2
General Check the product upon receipt for any visible damage which may have been caused during shipping. Physical Deployment This equipment must be installed and operated in accordance with instructions found in this document. Failure to comply with these instructions will invalidate the warranty.
Page 3
Top View (Receiver) Side View Network cable panel Ethernet panel 1 - Power input; 2 - LED indicators; 3 - Network cable connector; 4 - Ethernet RJ45 port; 5 – Grounding terminal. Color Status Description Green Power supply is normal. U-LINK Green EoU connection is normal.
Page 4
Ethernet RJ45 Definition Signal Notes: ★ Please use straight-through cable rather than cross-over cable. 8 wires transmission: all 8 wires need to be connected. 4 wires transmission: any 2 wires of PIN 1,2,4 and 5 as “+”, any 2 wires of PIN 3,6,7 and 8 as “-”.
Specifications Item Description Power Input 12/24VDC Power Consumption <2W Transmission Medium Cat5e/6 cable Operating Frequency 2M~28M Modulation Wavelet-OFDM Transmission Rate 210Mbps (Max.) Cable Power Negotiation Cycle Overcurrent 720mA Overcurrent Protection Time <2mS Transmission Distance *600m Transmission Medium Cat5e/6 Ethernet Port Standard IEEE802.3, IEEE802.3U Ethernet Delay...
Installation Instructions Please check the following items before installation. If any missing, please contact the dealer. ⚫ EoU transmitter/receiver ------------x1 Wall mounting clamp -----------------x1 ⚫ QSG/User manual ---------------------x1 ⚫ Screws ----------------------------------x2 ⚫ Please follow the installation steps below: Attach the clamp to the wall using the 3X10mm screws. Press the transmitter/receiver into the clamp.
Please replace the failed device with a known working unit to determine ⚫ if you have a damaged or faulty unit. If the problem persists, please contact your nearest KBC office or dealer. ⚫ Need Help? Please visit our website www.kbcnetworks.com...