Gigabyte X299-WU8 User Manual page 75

C-3. Configuring Legacy RAID ROM
Enter the Intel legacy RAID BIOS setup utility to configure a RAID array. Skip this step and proceed with the
®
installation of Windows operating system for a non-RAID configuration.
Step 1:
In BIOS Setup, go to BIOS and set CSM Support to Enabled and Storage Boot Option Control to Legacy. Next,
go to Peripherals\SATA And RST Configuration and make sure USE RST Legacy OROM is set to Enabled.
Save the changes and exit BIOS Setup. After the POST memory test begins and before the operating system
boot begins, look for a message which says "Press <Ctrl-I> to enter Configuration Utility" (Figure 13). Press
<Ctrl> + <I> to enter the RAID Configuration Utility.
Intel(R) Rapid Storage Technology - Option ROM - 15.7.0.2925
Copyright (C) Intel Corporation. All Rights Reserved.
RAID Volumes :
None defined.
Physical Devices :
ID Device Model
1 TOSHIBA DT01ACA1
2 TOSHIBA DT01ACA1
Press <CTRL - I> to enter Configuration Utility...
Step 2:
After you press <Ctrl> + <I>, the MAIN MENU screen will appear (Figure 14).
Create RAID Volume
If you want to create a RAID array, select Create RAID Volume in MAIN MENU and press <Enter>.
Intel(R) Rapid Storage Technology - Option ROM - 15.7.0.2925
1. Create RAID Volume
2. Delete RAID Volume
3. Reset Disks to Non-RAID
RAID Volumes :
None defined.
Physical Deivces :
ID Device Model
1 TOSHIBA DT01ACA1
2 TOSHIBA DT01ACA1
[hi]-Select
Serial #
763ZLL4FS
763ZM7MFS
Figure 13
Copyright (C) Intel Corporation. All Rights Reserved.
[ MAIN MENU ]
[ DISK/VOLUME INFORMATION ]
Serial #
763ZLL4FS
763ZM7MFS
[ESC]-Exit
Figure 14
- 75 -
Size Type/Status(Vol ID)
931.5GB Non-RAID Disk
931.5GB Non-RAID Disk
4. Recovery Volume Options
5. Acceleration Options
6. Exit
Size Type/Status(Vol ID)
931.5GB Non-RAID Disk
931.5GB Non-RAID Disk
[ENTER]-Select Menu
Configuring a RAID Set