Peripherals - Gigabyte X299-WU8 User Manual

2-6

Peripherals

& Initial Display Output
Specifies the first initiation of the monitor display from the PCI Express graphics cards.
Sets the graphics card on the PCIEX16_1 slot as the first display. (Default)
PCIe 1 Slot
Sets the graphics card on the PCIEX8_1 slot as the first display.
PCIe 2 Slot
Sets the graphics card on the PCIEX16_2 slot as the first display.
PCIe 3 Slot
Sets the graphics card on the PCIEX8_2 slot as the first display.
PCIe 4 Slot
Sets the graphics card on the PCIEX16_3 slot as the first display.
PCIe 5 Slot
Sets the graphics card on the PCIEX8_3 slot as the first display.
PCIe 6 Slot
Sets the graphics card on the PCIEX16_4 slot as the first display.
PCIe 7 Slot
& OnBoard LAN Controller (LAN2)
Enables or disables the onboard LAN function. (Default: Enabled)
If you wish to install a 3rd party add-in network card instead of using the onboard LAN, set this item to
Disabled.
& EZ RAID
Allows you to quickly set up a RAID array. Refer to Chapter 3, "Configuring a RAID Set," for instructions
on configuring a RAID array.
& Above 4G Decoding
Enables or disables 64-bit capable devices to be decoded in above 4 GB address space (only if your system
supports 64-bit PCI decoding). Set to Enabled if more than one advanced graphics card are installed and
their drivers are not able to be launched when entering the operating system (because of the limited 4 GB
memory address space). (Default: Disabled)
& LEDs in System Power On State
Allows you to enable or disable motherboard LED lighting when the system is on.
Disables the selected lighting mode when the system is on.
Off
Enables the selected lighting mode when the system is on. (Default)
On
- 59 - BIOS Setup