Gigabyte X299-WU8 User Manual page 68

B. Configuring SATA controller mode in BIOS Setup
Make sure to configure the SATA controller mode correctly in system BIOS Setup.
Step 1:
Turn on your computer and press <Delete> to enter BIOS Setup during the POST (Power-On Self-Test). Go to
Peripherals\SATA And RST Configuration, make sure SATA Controller(s) is enabled. To create RAID, set
SATA Mode Selection to Intel RST Premium (Figure 1). Note: When using a PCIe SSD, make sure to set the
Use RST Legacy OROM item under Peripherals\SATA And RST Configuration to Disabled. Then depending
the M.2 connector you use. Finally, save the settings and exit BIOS Setup.
Step 2:
To use the EZ RAID feature, follow the steps in "C-1." To configure UEFI RAID, follow the steps in "C-2." To
enter the legacy RAID ROM, refer to "C-3" for more information. Finally, save the settings and exit BIOS Setup.
The BIOS Setup menus described in this section may differ from the exact settings for your motherboard.
The actual BIOS Setup menu options you will see shall depend on the motherboard you have and
the BIOS version.
Configuring a RAID Set
Figure 1
- 68 -