Table of Contents
Advertisement
ENGLISH (Original instructions)
SPECIFICATIONS
Wheel diameter
Max. cutting capacities
No load speed (min
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• When used with 105 mm diamter wheel, max cutting capacities are somewhat smaller than those for 110 mm diameter wheel above
shown.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Read instruction manual.
･
DOUBLE INSULATION
･
Only for EU countries
Do not dispose of electric equipment
together
material!
In
observance
Directive,
Electronic
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
an
recycling facility.
Intended use
The tool is intended for cutting in brick, concrete and
stone.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Model
at 90°
at 45°
-1
)
Overall length
Net weight
Safety class
with
household
of
the
on
Waste
Electric
Equipment
environmentally
compatible
END201-7
General Power Tool Safety
Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and
instructions for future reference.
waste
The term "power tool" in the warnings refers to your
European
mains-operated (corded) power tool or battery-operated
and
(cordless) power tool.
and
its
Work area safety
1.
Keep work area clean and well lit. Cluttered or
dark areas invite accidents.
2.
Do not operate power tools in explosive
atmospheres, such as in the presence of
flammable liquids, gases or dust. Power tools
create sparks which may ignite the dust or fumes.
ENE023-2
3.
Keep children and bystanders away while
operating a power tool. Distractions can cause
you to lose control.
Electrical safety
ENF002-2
4.
Power tool plugs must match the outlet. Never
modify the plug in any way. Do not use any
adapter plugs with earthed (grounded) power
tools. Unmodified plugs and matching outlets will
reduce risk of electric shock.
5.
Avoid body contact with earthed or grounded
surfaces such as pipes, radiators, ranges and
refrigerators. There is an increased risk of
electric shock if your body is earthed or grounded.
2
4100NH2
110 mm
32.5 mm
21.5 mm
12,200
238 mm
3.0 kg
/II
125 mm
40 mm
27 mm
GEA005-3
Advertisement
Table of Contents
