DFI G586VPM/T User Manual page 11

2. Remove the system unit cover. Refer to the manufacturer' s in-
structions if necessary.
3. Remove expansion cards seated in any of the expansion slots and
detach all connectors from the old system board.
4. Loosen the screws holding the original system board and remove
the board from the system. Save the screws.
5. Remove the G586VPM/T from its original packing box. Be careful
to avoid touching all connectors and pins on the board. Please refer
to the handling instructions on pages 9-10 for proper handling tech-
niques.
6. Insert the SIMMs into the SIMM banks on the G586VPM/T. The
quantity and location of the SIMMs is dependent upon the memory
configuration and type of modules you intend to use.
7. Insert the cache module, if any, into the cache module slot on the
G586VPM/T.
8. Install the CPU. Be sure pin 1 of the CPU is aligned with pin 1 of
the socket.
9. Set the corresponding jumpers.
10. Install the prepared G586VPM/T system board into the case and
replace the screws.
11.
Reinstall all cards and connectors and replace the system unit
cover. Reconnect all power cords and cables.
11