Table of Contents
Advertisement
2.2 HARDWARE CONNECTION
Introduction：
1、 Use a telephone cord to connect the LINE port of the splitter with the RJ-11 port (the phone jack) on
the wall.
2、 Use another telephone cord to connect the ADSL port of the splitter with the LINE port of the ADSL
Modem.
3、 Use another telephone cord to connect the telephone set with the PHONE port of the splitter.
4、 Connect Ethernet port of the ADSL MODEM with 10/100BASE-T port of the computer using the
network cable that comes with the modem.
5、 Plug in the power cord, and turn on the power.
If you do not want Internet services and telephone voice services simultaneously, please just connect the
LINE port of the ADSL Modem with the RJ-11 port (the phone jack) on the wall using a telephone cord. In this
case, the splitter is not necessary.
2.3 LED STATUS INDICATION
Status
POWER (red)
Steady light
Power on
Flashing
/
Fast flashing
/
Off
Power off
Table 2.3
DSL (yellow)
The modem is in good
connection
In handshaking status
/
Connection not set up
Page 5
INTERNET (green)
Connected with PC
/
Transmitting
or
receiving
data
Not connected with PC
properly
User Manual
WIRELESS(green)
Wireless
is
connected
/
Transforming data
Wireless is disabled
Total 20 Pages
Advertisement
Table of Contents
