Table of Contents
Advertisement
2 SPECIFICATION
2.1 INTERFACE INTRODUCTION
2.1.1 INDICATOR AND INTERFACE
Table 2.1
ITEM
Name
POWER
DSL
Indicator
INTERNET
WLAN
LINE
ETHERNET
POWER
Interface
SWITCH
RESET
WIRELESS
2.1.2 SPLITTER SPEC
Table 2.2
2.2 HARDWARE CONNECTION
Introduction：
1、 Use a telephone cord to connect the LINE port of the splitter with the RJ-11 port (the phone jack) on
the wall.
2、 Use another telephone cord to connect the ADSL port of the splitter with the LINE port of the ADSL
Modem.
3、 Use another telephone cord to connect the telephone set with the PHONE port of the splitter.
4、 Connect Ethernet port of the ADSL MODEM with 10/100BASE-T port of the computer using the
network cable that comes with the modem.
5、 Plug in the power cord, and turn on the power.
If you do not want Internet services and telephone voice services simultaneously, please just connect the
LINE port of the ADSL Modem with the RJ-11 port (the phone jack) on the wall using a telephone cord. In this
case, the splitter is not necessary.
State introduction
A steady Green light means the power connection works properly
Green, show DSL line status.
Green, Flashing means the Modem is transmitting or receiving data
Green, Indicates status of connection to the wireless device
Connected with phone line or "ADSL" port of the splitter.
To be connected to a PC network card by a straight-through network cable, also
can use a crossover cable to connect to Hub, Switch or Router.
Power interface, Connect with power adapter.
To turn on / off the power.
Press the reset button and turn on the power, then keep pressing the reset button for
3 seconds. Then you can reset the modem with the default settings.
Open/Close wireless via pressing the button
Interface
Introduction
LINE
Connected with telephone line
Connect with the LINE port of the
ADSL
ADSL Modem using telephone
line provided.
PHONE
Connect with telephone
Page 4
DSL Gateway/Router — User Manual
Total 24 Pages
Advertisement
Table of Contents
