Table of Contents
Advertisement
INSTALLATION ERRORS
To operate efficiently the air must be able to flow freely into the exhaust hose. To assist
this:
•
Avoid any sharp bends or kinks in the exhaust hose.
•
Keep it as level as possible.
•
Keep its length as short as possible. The maximum extension length of the
exhaust pipe is 1.5m. Do not try to lengthen it.
CONTROL PANEL
•
POWER: Press to turn the air conditioner on or off. When it turns on, it will do so in
the default mode of cooling with low fan speed.
•
MODE: press this key to select cooling, heating, dehumidifying and fan mode.
•
FAN: press this key to select the fan speed (high, middle or low). Not available in
sleep or dehumidifying modes.
•
DOWN: in timer mode this reduces the time setting. In cooling mode, press this
key to reduce the temperature.
•
UP: in timer mode this increases the time setting. In cooling mode, press this key
to increase the temperature.
•
SLEEP: When the power is on and in the cooling mode (or heating mode), press
the button to start the sleep mode. Under sleep mode, the FAN speed is set to
LOW speed and not adjustable. The sleep mode can be cancelled by pressing the
button again.
•
TIMER: in the power-on or standby mode, press this key to setup on/off delay
timer from 1 to 24 hours using the UP or DOWN buttons.
•
SWING: Press once and the louvre will swing continuously left and right. Press the
button again and the louvre will stop moving.
•
All functions can also be accessed using the remote control.
6
REMOTE CONTROL
1. POWER
2. TIMER
3. SWING
4. SLEEP
5. UP/DOWN
6. MODE
7. FAN
OPERATION MODES
Cooling/Heating Mode
•
After the air conditioner turns on, the default setting is cooling mode with a
temperature of 22°C and low fan speed.
•
Press MODE to select cooling mode and the cooling mode indicator turns on.
•
Press UP or DOWN to adjust temperature from 16°C to 31°C.
Press FAN to select high or low fan speed.
•
Fan Mode
•
Press MODE to select fan mode and the fan mode indicator turns on.
•
Press FAN to select high speed or low speed.
Note: When in fan mode, the temperature and sleep function cannot be set.
Timer Mode
•
In standby mode, press TIMER to set the number of hours to when the unit turns
on. The timer mode indicator turns on. The length of time is adjustable from 1 to 24
hours.
•
In power-on mode, press TIMER to set the number of hours to when the unit
goes into standby mode. The timer mode indicator turns on. The length of time is
adjustable from 1 to 24 hours.
Dehumidifying Mode
•
Press MODE to select dehumidifying mode and the dehumidifying indicator turns on.
Note: In dehumidifying mode, the sleep function cannot be set up and the fan speed
is low.
Sleep Mode
•
Press SLEEP to enter into sleep mode; the default value of the fan speed is low.
When sleep mode turns on, in cooling mode, after the first hour the temperature setting
will increase by 1°C. After the second hour, the temperature will go up a further 1°C
and then remain the same.
1
5
6
2
3
7
4
8
7
Advertisement
Table of Contents
