Adjusting The Water Softening System - Beko DIT39432 User Manual

8. ADJUSTING THE WATER SOFTENING SYSTEM

(Select Models)
Cleaning, rinsing and drying performance of your dishwasher will increase when water
softening system is adjusted properly.
Adjust the new water hardness level according to the Water hardness level instruction in
this booklet.
Use the test strip supplied with the product according to the steps given below to
determine hardness level of your supply water.
a b
Remove the test Turn on the tap and
strip from the let the water run for
packet. about a minute.
After determining hardness level of the supply water:
1. After switching on your machine, long press the Menu key
2. Pres the settings menu key for 3 seconds to enter the Settings Menu.
3. Using <- and +> keys, proceed until the water hardness setting indicator becomes on
("r" position will be displayed).
4. Using the Selection key, adjust water hardness level according to the hardness of the
supply water. For correct setting please see "Water hardness level setting table".
5. Press the Menu key to exit the settings menu. Your setting will be saved automatically.
Water hardness level adjustment table
Hardness Grains Per
Level Gallon (gpg)
Level 0
0-14
Level 1
15-22
Level 2
23-37
Level 3
38-46
Level 4
47-58
Level 5
59-154
If the hardness level of the supply water is above 154 gpg (grains per gallon) or if you are
using well water, then it is recommended to use water purification devices and special
filters.
If the hardness level of the supply water is below 22 gpg, there is no need to use salt
in your dishwasher. If this is the case, "No Salt Warning Indicator" (if any) illuminates
continuously on the panel of your machine.
c
1 min.
1 Second
Hold the test strip in
the water for about
a second.
German Water French Water
Hardness °dF Water Hardness Level Indicator
Hardness °dH
0-4 0-8
5-7 9-13
8-12 14-22
13-15 23-27
16-19 28-34
20-50 35-90
d
Remove the test
strip from the water
and shake it.
Press the Selection key to switch the water
hardness level to position 1. (r1)
Press the Selection key to switch the water
hardness level to position 2. (r2)
Press the Selection key to switch the water
hardness level to position 3. (r3)
Press the Selection key to switch the water
hardness level to position 4. (r4)
Press the Selection key to switch the water
hardness level to position 5. (r5)
34
USA
e f
1 Minute
Wait for 1 minute. The test strip shows
you the hardness
level.