Smeg LBI147 Instruction Manual page 20

4.14 INTERRUPTING OR CHANGING THE WASHING PROGRAMME

The washing programme in progress can be interrupted at any moment:

1. Press the "Start/Pause" button for about 3 seconds: the display shows the word PAUS (for 1

second) alternating with the time remaining until the end of the cycle (for 1 second). The

Start/Pause light flashes on and off.

Programmes can also be interrupted by turning the programme/temperature setting knob while

the cycle is in progress.

2. To change the washing programme, simply turn the programme knob to select the new pro-

gramme; there is no need to set the appliance in pause status. The new cycle will be carried

out completely, beginning from the start. If the tank had already been filled with water during

the previous cycle, the water intake phase will be omitted from the new programme.

3. To restart the cycle, press the Start-Pause button again.

4.15 PROGRAMME END

Washing programmes are completed automatically. The word END appears on the display and the

"Time remaining" light goes out.

1. Switch the appliance off by turning the programmes knob to OFF

2. Unload the laundry from the drum.

3. Leave the door ajar to allow the interior of the washing machine to dry out.

4. Turn off the water intake tap.

If during the initial spin speed setting stage, the "no spin" mode with stop with tank full

speed set as 0) was selected, at the end of the washing programme the word STOP appears on the

display, alternating with ---- (spin speed of 0) and the spin light is on.

To proceed with the pump-out and spin, press the spin selection button twice. The appliance restarts

the cycle with the pump-out and spin. To select the spin speed required, press the button until the cho-

sen speed is displayed. To pump out the water from the tank without performing the spin, press the

spin selection button until the display indicates speed of 0: the pump-out will be run without spin.

4.16 CHILD LOCK

1. When this function is activated, the modification of options, temperatures, spin speed and the

washing/drying cycle is not possible while the cycle is in progress.

2. To activate the Child Lock Function, press the Child Lock (1) button and hold it down. Also

press the Option selection (2) button within 3 seconds.

3. The Child Safety Function symbol lights up to show that the function has been activated.

4. Repeat the same procedure to deactivate the function.

Child Lock Symbol

(spin