Alfa Network AC1200 User Manual page 53

 Enable Dynamic Route Click this box to enable Dynamic Route.
Transmit enable RIPv1 or RIPv2 protocol on outgoing data.

Receive enable RIPv1 or RIPv2 protocol on incoming data.

Enable Static Route Click this box to enable static route.

 IP Address The network or host IP address desired to access.
Subnet Mask The subnet mask of destination IP.

Gateway The gateway is the router or host's IP address to which packet was sent. It must

be the same network segment with the WAN or LAN port.
Show Routing Table Clicking this button will show you all the routing table of the system.

Static Routing table It only shows the static routing table and you can delete one or all.

Figure 4-35 Route setup menu
- 48 -
AC1200R User's Guide