Table of Contents
Advertisement
IAPP IAPP (Inter-Access Point Protocol) enabled is recommendation that describes an
optional extension to IEEE 802.11 that provides wireless access-point communications
among multivendor systems. Default is "Enabled".
Protection It is recommended to enable the protection mechanism. This mechanism can
decrease the rate of data collision between 802.11b and 802.11g wireless stations. When the
protection mode is enabled, the throughput of the AP will be a little lower due to many of
frame traffic should be transmitted. Default is "Disabled"
Aggregation It is a function where the values of multiple rows are grouped together. Default
is "Enabled"
Short GI It is used to set the time that the receiver waits for RF reflections to settle out before
sampling data. Default is "Enabled
WLAN Partition This feature also called "WLAN isolation" or "Block Relay". If this is enabled,
wireless clients cannot exchange data through the router. Default is "Disabled".
STBC Activate Space Time Blocking Code (STBC) which does not need channel statement
information (CSI). Default Setting: "Disabled"
20/40MHz Coexist Configure 20/40MHz coexisting scheme. If you set up as "Enabled",
"20MHz" and "40MHz" will coexist. Default Setting: "Disabled"
RF Output Power Users can adjust the wireless output power here. Default is "100%".
- 32 -
AC1200R User's Guide
Advertisement
Table of Contents
