Installing MOTOMESH Client Software on Windows
2000
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
The following procedure outlines the installation of MOTOMESH client software on a typical
Windows 2000 platform. Some of the steps may vary slightly based on the configuration of an
individual computer.
Complete the following procedure to install the MOTOMESH client software:
Procedure 2-2
MOTOMESH Client Software Installation on Windows 2000
Close and exit any existing MOTOMESH applications running on the computer prior to installation.
1
Insert the MOTOMESH Software and Documentation CD into the CD-ROM drive. The installation
2
should begin automatically.
If the installation program does not start automatically, select Start | Run then type
3
d:\setupmotomeshclient.exe (where d: specifies the CD-ROM drive)
Click the OK button.
The MOTOMESH Setup program will be displayed as shown in
4
continue the installation process.
Figure 2-11
6881011Y52-D January 2007
MOTOMESH Setup - Installer Setup Dialog Box (W2K))
MOTOMESH 1.2 Wireless Modem Card Users Guide
.
.
Figure
2-7
2-11, select the Next button to