Advertisement
NOTES:
1.
Install Key 41 (Bearing) into Key 42 (Clutch Sleeve) with lettered end of bearing on end
opposite of groove in clutch sleeve. Non-lettered end of bearing to installed flush with the
grooved end of clutch sleeve.
2.
For optimum tool performance, fill gear housing (Key 38) one-third full of Red Mobilith SHC
007 Grease (Signode Part No. 425239).
3.
Key numbers 39 (Clutch Spring) and 40 (Spring Seat) can be order together as Signode
Part Number 425631 (Spring/Seat Assembly).
4.
Key numbers 41 (Roller Clutch) and 42 (Clutch Sleeve) can be order together as Signode
Part Number 425632 (Clutch/Sleeve Assembly).
5.
Install Key 99 (Worm Gear) with the shoulder side facing the gear housing.
6.
Install Key 120 (Needle Bearing) flush with rear wall of
gear housing as shown in Figure "A".
7.
Key numbers 124, 125, 126 and 127 can be order
together as Signode Part Number 426159.
8.
Install Key 125 (Needle Bearing) in to Key 127 (Worm
Gear) bottomed out against Key 126 (Spacer) as
shown in Figure "B".
9.
Install Key 33 (Set Screw) flush with face of Key 26
(Wear Tab).
21
FIGURE - A
FIGURE - B
Advertisement
