Energy Consumption Indicator; Power Manager; Home Connect; Setting Up - Bosch NIT8669SUC Use And Care Manual

Energy consumption indicator

This function indicates the total amount of energy
consumed by this cooktop the last time it was used for
cooking.
Once switched off, the energy consumption in kWh is
displayed for 10 seconds, e.g.
The accuracy of the information displayed depends on
the voltage quality of the power supply, among other
factors.
You can find out how to turn this function on in the
section on ~ "Basic settings"

Home Connect

This appliance is Wi-Fi enabled and settings can be sent
to the appliance via a mobile device.
If the appliance is not connected to the home network,
the appliance functions in the same way as a cooktop
with no network connection. The cooktop can always be
operated via the control panel.
The availability of the Home Connect function depends
on the availability of Home Connect services in your
country. Home Connect services are not available in
every country. You can find more information on this at
www.home-connect.com.
Notes
Cooktops are not designed to be used unattended –
▯
you must always keep an eye on the cooking process.
Ensure that you follow the safety instructions in this
▯
instruction manual and that these are also observed
when operating the appliance via the Home Connect
app. Follow the instructions in the Home Connect app.
Using the Home Connect app, you can send settings
▯
to your appliance, and you must then confirm these on
the appliance. It is not possible to operate the
appliance while you are away from home.
If the appliance is being operated by the controls on
▯
the appliance itself, this mode of operation always has
priority. It is not possible to operate the appliance
using the Home Connect app during this time.
20
. kWh.
‚ ‹‰

Power Manager

You can use the power manager to set the total power of
the cooktop.
The cooktop is preset at the factory. Its maximum
performance is specified on the rating label. You can use
the power manager to change the value in accordance
with the requirements for the relevant electrical
installation.
In order not to exceed this set value, the cooktop
automatically distributes the power available between the
cooking zones that are switched on.
As long as the power manager function is activated, the
output of a cooking zone may temporarily fall below the
nominal value. If a cooking zone is switched on and the
power limit is reached,
¬
display for a short time. The appliance automatically
regulates and selects the highest possible power level.
For more information about how the total power of the
cooktop is changed, see section ~ "Basic settings"

Setting Up

To implement settings via Home Connect, you must have
installed and set up the Home Connect app on your
mobile device.
Refer to the supplied Home Connect documents for
more information.
Follow the steps specified by the app to implement the
settings.
The app must be open in order to perform the setup
process.
Automatic Registration in the Home Network
You require a routher that has WPS functionality. If you
do not have this, follow the steps under "Manually
logging into your home network".
Turn on the cooktop.
1.
Touch and hold the kitchen timer key for 4 seconds.
2.
The product information is displayed.
Touch the kitchen timer key repeatedly until
3.
are displayed alternately.
‚
‹ lights up in the cooking zone display.
appears in the heat setting
•'
and