Abus FUBW50022 User Manual page 33

Fig. 9
Program button
(backside of the PCB)
Example – To configure the pulse counter from the default setting "1" to "2" ...

Press the program button two times and then release.

Wait until the display goes out.

The display flashes once to indicate the current setting.

Press the program button two times to change to setting "2" and then release.

The display flashes two times to indicate that the option has been saved and the
detector returns to normal mode.
Changing the settings
To change the settings, press the program button [Fig. 9]
for the option to change – i.e. 1 x for range and 2 x for
pulse counter. Wait 4 seconds until the red LED display
goes out. The current setting appears on the display. To
change the setting for this option, press the button until
you reach the required setting. The display lights up two
times and the changes are saved. (All changes made to
the settings are transferred to the memory of the detector
and remain there even if the power supply is interrupted.)
Red LED
33