Troubleshooting - Summit SCFU386CSS Instruction Manual

You can solve many common problems easily, saving you the cost of a possible service call.
Try the suggestions below to see if you can solve the problem before calling the servicer.
PROBLEM
The unit does not
operate.
The internal
temperature is too low.
The internal
temperature is too high.
Compressor operates
continuously.
Operation is too noisy.
Light is not on.
If the freezer develops problems that cannot be solved by referring to the chart above,
do not try to dismantle the unit yourself. This could void your warranty. Instead, refer
to an authorized service center or call SUMMIT Customer Service at 1-800-932-4267.

TROUBLESHOOTING

Troubleshooting Guide
POSSIBLE CAUSE
Temperature control is set to 0
Bad plug connection
Tripped circuit breaker or blown fuse
Temperature control is set too high.
Thermostat does not work.
Temperature control is set too low.
Poor heat dissipation and ventilation
of condenser
Too much warm food was put in at
one time.
Too much food stored at one time.
Doors were opened frequently or
held open too long.
Thick frost
Freezer is too near a source of heat.
The appliance is not level.
The freezer is too close to a wall or
cabinet.
Light switch is off.
Bulb is burned out.
Adjust temperature control.
Reconnect the plug to power
source.
Reset circuit breaker or replace
fuse.
Adjust temperature control.
Call our service department for
repair suggestions.
Adjust temperature control.
Allow more space at back of
freezer. Be sure ventilation slots
are clear.
Allow food to come to room
temperature before putting into
freezer.
Reduce the quantity of stored
food.
Decrease frequency and length of
time of door opening.
Defrost.
Relocate the unit.
Level or relocate the appliance.
Move the unit away from the
adjacent surface.
Turn on switch at back of cabinet.
Call Service Center.
11
SOLUTION