Table of Contents
Advertisement
network connection and setup
USING DEVICE MANAGER
`
M
Device manager program can be downloaded from <Technical Guides>-<Online Tool> menu at Hanwha Techwin website
(http://www.hanwha-security.com).
`
More instructions of Device Manager can be found at <Help> menu of the main page.
SEARCHING CAMERA AUTOMATICALLY
If a camera is connected to the same network of the PC where device manager is installed, you
can find any network camera by using search function.
1. Click <Search> at the main page of the device manager.
2. Check the camera from the list.
~ Check MAC address at the sticker attached to the camera.
CONFIGURING IP ADDRESS
If you want to change camera network setting, <Login OK> sign must be displayed at <Status>.
Click <Authentication> at the main page to log in.
Configuring Static IP
Manually insert and configure IP address & port information.
1. Click the camera that you want to change the IP setting at
the list.
2. Click <IP Assign> at the main page of the device manager.
3. Select <Assign the following IP address>.
~ IP information of the camera will be displayed as previously
set.
4. Fill in IP & Port related categories.
If not using a Broadband Router
For setting <IP Address>, <Subnet Mask>, and <Gateway>, contact your network administrator.
~ HTTP Port : Used to access the camera using the Internet browser. The default value is 80.
~ RTSP Port: Used to control real-time streaming. The default value is 554.
14_ network connection and setup
If using a Broadband Router
~ IP Address : Enter an address falling in the IP range provided
by the Broadband Router.
ex) 192.168.1.2~254, 192.168.0.2~254,
192.168.XXX.2~254
~ Subnet Mask : The <Subnet Mask> of the Broadband Router
will be the <Subnet Mask> of the camera.
~ Gateway : The <Local IP Address> of the Broadband Router
will be the <Gateway> of the camera.
`
M
The settings may differ depending on the connected Broadband Router model.
For more information, refer to the user manual of the applicable router.
`
For more information about port forwarding of the broadband router, refer to "Port Range Forward (Port Mapping) Setup".
(Page 16)
If the Broadband Router has more than one camera connected
Configure the IP related settings and the Port related settings distinctly with each other.
ex)
Category
IP Address
IP related settings
Subnet Mask
Gateway
HTTP Port
Port related settings
RTSP Port
`
M
If the <HTTP Port> is set other than 80, you must provide the <Port> number in the address bar of the Internet browser
before you can access the camera.
ex) http://IP address : HTTP Port
http://192.168.1.100:8080
5. Click [Apply] Button.
6. If the success message is displayed, click [OK].
Camera #1
Camera #2
192.168.1.100
192.168.1.101
255.255.255.0
255.255.255.0
192.168.1.1
192.168.1.1
8080
8081
554
555
Advertisement
Table of Contents
