Table of Contents
Advertisement
installation & connection
Power Supply
Use the screwdriver to connect each line (+, –) of the power cable to the corresponding power port of the
camera.
`
J
If the power sources for PoE+ and DC 12 V are simultaneously turned on, the device power will be supplied by both of PoE+
and DC 12 V.
- You can also use a router featuring PoE+ to supply power to the camera.
- It is advisable to use only one power source from PoE+ and DC 12 V.
`
Be careful not to reverse the polarity when you connect the power cable.
`
When the power is initially turned on, time is needed to allow the screen stabilized. For this reason, a screen calibration is
performed when the power is initially turned on.
`
If you want to connect an external device, you must turn off the external device before proceeding.
`
Connect the set and the adapter power line first, and then connect the power cable to the outlet on the wall.
Power Cable Specification
In case of DC 12V Input:
Wire Type (AWG)
Cable Length (Max.)
10_ installation & connection
#20
#18
#16
10m
17m
27m
Grounding the Product
Connect the ground wire to the ground terminal which is located above the power input terminal by using a
screwdriver.
J
`
Grounding protects the product from a surge or lightning.
`
When grounding, make sure to turn the product's power off.
Recommended Grounding Cable
~ Length : Less than 3M
~ Gauge : 18 AWG or bigger
Ex) UL1007 AWG 18/16, UL1015 AWG18/16/14/12
Advertisement
Table of Contents
