Installation - AGA marvel AMPROFD23D Use & Installation Manual

Installation

Required Tools
You will need the following tools:
This Use & Care Guide provides general installation
and operating instructions for your model. We recom-
mend using a service or kitchen contracting profession-
al to install your refrigerator. Use the refrigerator only
as instructed in this Use & Care Guide. Before starting
the refrigerator, follow these important fi rst steps.
Location
• Choose a place that is near a grounded, non-GFCI,
electrical outlet. Do Not use an extension cord or an
adapter plug.
• If possible, place the refrigerator out of direct sunlight
and away from the range, dishwasher, or other heat
sources.
• The refrigerator must be installed on a fl oor that is
level and strong enough to support a fully loaded
refrigerator.
• Consider water supply availability for models
equipped with an automatic ice maker.
Installation
• Allow the following clearances for ease of installation,
proper air circulation, and plumbing and electrical
connections:
Sides & Top
Back
CAUTION
DO NOT install the refrigerator where the
temperature will drop below 55°F (13°C) or rise
above 110°F (43°C). The compressor will not be
able to maintain proper temperatures inside the
refrigerator.
DO NOT block the toe grille on the lower front
of your refrigerator. Suffi cient air circulation
is essential for the proper operation of your
refrigerator.
Tools Necessary:
Phillips Head
or
Quadrex Head
Screwdriver
⅜ inch (9.5 mm)
1 inch (25.4 mm)
(OR)
AND AND
6mm
Allen Wrench
Door opening
NOTE
If your refrigerator is placed with the door hinge
against a wall, you may have to allow additional
space so the door can be opened wider.
NOTE
The refrigerator doors are designed to shut by
themselves within a 20 degree opening.
Your refrigerator should be positioned to allow easy
access to a counter when removing food. For best
use of refrigerator drawers and freezer baskets, the
refrigerator should be in a position where both can be
fully opened.
CAUTION
Do Not loosen or remove these (3) hex head
screws.
6
OR
OR
⅜" and ¼"
Socket Adjustable
Wrench Wrench
DO NOT
Remove
These 3
⅜" Fixed
Wrench
Loosen
or
Hex
Screws